Top 10 Mb S430 Gps Shark Fin Antenna

The Garmin GA 38 GPS/GLONASS antenna was built to take advantage of the GLONASS system/constellation of satellites as well as standard GPS, this robust external antenna is packaged in a low-profile water resistant housing and provides 3 easy mounting solutions: pole, surface or under-deck (for the underside of fiberglass decks).

ACDelco GM Original Equipment GPS Navigation System Antenna is a GM-recommended replacement component for one or more of the following vehicle systems: body-electrical and lighting. This original equipment antenna will provide the same performance, durability, and service life you expect from General Motors.

Increase your signal with this waterproof GPS external antenna with built in low noise amplifier (LNA). This GPS antenna provides 28 dB of gain with its built in LNA. The industry standard SMA connector will work with most GPS systems and the magnetic base allows you to conveniently attach it to to the roof of your car.
Technical Specs
1. Dielectric Antenna
Center Frequency: 1575.42MHz ±3MHz
V.S.W.R: 2:01
Bandwidth: ±5 MHz
Impedance: 50
Peak Gain: > 3dBic based on 7x7cm ground plane
Gain Coverage: > -4dBic at -90 < 0="">< 90="" (over="" 75="">
Polarization: RHCP
2. LNA/Filter
LNA Gain Without cable: 28dB Typical
Noise Figure: 2.0dB
Filter Out Band Attenuation: (f0=1575.42MHz)
7dB Min f0+/-20MHz;
20dB Min f0+/-50MHz;
30dB Min f0+/-100MHz
V.S.W.R: <>
DC Voltage: 3V to 5V
DC current: 7-10MA
3. Overall
Frequency Range: 1575/1609MHz
V.S.W.R: 2.0
Gain: 30±3dBic
Impedance: 50?
3. Mechanical
Weight: 60 gram
Size: 45x38x15mm
Cable: RG174
Length: 3m
Connector: SMA
Mounting: Magnet base
Housing: Black
4. Environmental
Working Temp: -40 to 85℃
Waterproof test: 4 hours under the tap, let the water rush over the housing;
Vibration: Sine sweep 1g (0-p) 10 ~ 50 ~ 10Hz each axis
Humidity: 95% ~ 100% R

Standard Style: Receiving body consists of 2 soft boards According the relation of electric field magnetic field, the charge density and current density,Use the PET / FPC as the main collect the RF signal,Receiving signal better, more efficient and more stable. Advance Style: The dipoles are printed on the front of the soft board body in a metal printed circuit manner; a first dipole, a second dipole and a third dipole are arranged.symmetric distribution 6pcs soft boards together. According the relation of electric field magnetic field, the charge density and current density,Use the PET / FPC as the main collect the RF signal,Receiving signal better, more efficient and more stable.

If you want to buy more products about Folconroad, please don’t hesitate to contact us. If you are a business customer, we support wholesale, more preferential prices are waiting for you.

Fit for 2017 2018 Jeep Compass
Fit for 2018 2019 Cherokee Latitude(It is the same size)

Feature:

1) The design is amazing, concision and modern.
2) Make your car cool and distinctive.
3) It can enhance the signal and achieve the purpose of decoration
4) Double-sided adhesive tape, easy installation.
5) Durable item, no drilling required.

Note:

1) Please confirm your size before ordering it.
2) All dimensions are measured by hand, there may be small deviations.
3) Don’t wash the car within 24 hours after installation, so tape can hold on its place best.
Tips:

Just be sure to wipe the area down with alcohol before you place the antenna shell on the roof.

The new Wilson Electronics’ 304422 4G Building Antenna for Enterprise is a robust 50 ohm Omni-Directional Antenna for mounting outside of a building and features up to 5.0 dB of gain. It is designed to receive 3G/4G LTE cell phone signal for all US and Canada carriers from all directions, and should be mounted in the area with the strongest signal. The included mounting hardware allows the antenna to be installed vertically on a pole and improves signal transmission between an amplifier and your nearest cellular signal tower.

Specifications:
1. Dielectric Antenna
Center Frequency: 1575.42MHz ±3MHz
V.S.W.R: 2:01
Bandwidth: ±5 MHz
Impedance: 50
Peak Gain: > 3dBic based on 7x7cm ground plane
Gain Coverage: > -4dBic at -90 < 0 < 90 (over 75 volume)
Polarization: RHCP
2. LNA/Filter
LNA Gain Without cable: 28dB Typical
Noise Figure: 2.0dB
Filter Out Band Attenuation: (f0=1575.42MHz)
7dB Min f0+/-20MHz;
20dB Min f0+/-50MHz;
30dB Min f0+/-100MHz
V.S.W.R: < 2.0
DC Voltage: 3V to 5V
DC current: 7-10MA
3. Overall
Frequency Range: 1575/1609MHz
V.S.W.R: 2.0
Gain: 30±3dBic
Impedance: 50 Ohm
3. Mechanical
Weight: 60 gram
Size: 35x30x15mm
Cable: RG174
Length: 3m
Connector: Fakra C Blue
Mounting: Magnet base
Housing: Black
4. Environmental
Working Temp: -40 to 85℃
Waterproof test: 4 hours under the tap, let the water rush over the housing;
Vibration: Sine sweep 1g (0-p) 10 ~ 50 ~ 10Hz each axis
Humidity: 95% ~ 100% R
Package List: 1 x Antenna (As the Picture Shown)

Compatible with Navigation System:
2008-2010 Chrysler Town & Country
2008-2010 Dodge Grand Caravan
2008-2010 Dodge Journey
2007-2010 Dodge Nitro
2009-2010 Dodge Ram 1500
2010 Dodge Ram 2500
2010 Dodge Ram 3500
2008-2010 Jeep Liberty
2007-2010 Jeep Wrangler

2008-2010 Chrysler 300
2008-2009 Chrysler Aspen
2007-2010 Chrysler Sebring
2007-2010 Dodge Avenger
2009-2010 Dodge Caliber
2008-2010 Dodge Challenger
2008-2010 Dodge Charger
2008-2010 Dodge Dakota
2008-2009 Dodge Durango
2008 Dodge Magnum

2008-2010 Jeep Commander
2009-2010 Jeep Compass
2008-2010 Jeep Grand Cherokee
2009-2010 Jeep Patriot

Uprade ESP32 Development Board WIFI Bluetooth LoRa Dual Core 240MHz CP2102 with 0.96inch OLED Display and 433/470MHz Antenna for Arduino

Description:
WIFI Kit series is the new development cost-effective networking program of our company, the main chip using Lexin ESP32, Tensilica LX6 dual-core processor, clocked at 240MHz, computing power up to 600DMIPS, chip built-in 520 KB SRAM, 802.11 b / g / N HT40 Wi-Fi transceiver, baseband, protocol stack and LWIP, integrated dual-mode Bluetooth (traditional Bluetooth and BLE low power Bluetooth).
This product is based on the WIFI Kit 32 added SX1278 chip, that is, LoRa remote modem, 433MHz frequency, about -139dBm high sensitivity, +20 dBm power output, high reliability, transmission distance (measured open area communication distance 3.6Km).

Onboard 32MByte Flash, Wi-Fi antenna, 0.96-inch blue OLED display, lithium battery charging circuit and interface, CP2102 USB to serial chip, the perfect support for Arduino development environment, can be very simple and fast for program verification and product development.

Specification:
Operating voltage: 3.3V to 7V
Operating temperature range: -40 ° C to + 90 ° C
Supports Sniffer, Station, softAP and Wi-Fi Direct modes
Data rate: 150 Mbps 11n HT40,72 Mbps 11n HT20,54 Mbps 11g, 11 Mbps 11b
Transmit power: 19.5 dBm 11b, 16.5 dBm 11g, 15.5 dBm 11n
Receiver sensitivity up to – 139 dBm
UDP continues to throughput by 135 Mbps

Package Including
1 * Upgrade ESP32 Development Board with OLED
1 * 433/470MHz Antenna
1 * Pin sticker
2 * Pin headers

Specifications:
1. Dielectric Antenna
Center Frequency: 1575.42MHz ±3MHz
V.S.W.R: 2:01
Bandwidth: ±5 MHz
Impedance: 50
Peak Gain: > 3dBic based on 7x7cm ground plane
Gain Coverage: > -4dBic at -90 < 0="">< 90="" (over="" 75="">
Polarization: RHCP
2. LNA/Filter
LNA Gain Without cable: 28dB Typical
Noise Figure: 2.0dB
Filter Out Band Attenuation: (f0=1575.42MHz)
7dB Min f0+/-20MHz;
20dB Min f0+/-50MHz;
30dB Min f0+/-100MHz
V.S.W.R: <>
DC Voltage: 3V to 5V
DC current: 7-10MA
3. Overall
Frequency Range: 1575/1609MHz
V.S.W.R: 2.0
Gain: 30±3dBic
Impedance: 50 Ohm
3. Mechanical
Weight: 60 gram
Size: 35x30x15mm
Cable: RG174
Length: 3m
Connector: SMA Male Plug Connector
Mounting: Magnet base
Housing: Black
4. Environmental
Working Temp: -40 to 85℃
Waterproof test: 4 hours under the tap, let the water rush over the housing;
Vibration: Sine sweep 1g (0-p) 10 ~ 50 ~ 10Hz each axis
Humidity: 95% ~ 100% R
Package List: 1 x Antenna (As the Picture Shown)

Our Promise to Readers

We keep receiving tons of questions of readers who are going to buy Mb S430 Gps Shark Fin Antenna, eg:

• What are Top 10 Mb S430 Gps Shark Fin Antenna for 2020, for 2019, for 2018 or even 2017 (old models)?
• What is Top 10 Mb S430 Gps Shark Fin Antenna to buy?
• What are Top Rated Mb S430 Gps Shark Fin Antenna to buy on the market?
• or even What is Top 10 affordable (best budget, best cheap or even best expensive!!!) Mb S430 Gps Shark Fin Antenna?…
• All of these above questions make you crazy whenever coming up with them. We know your feelings because we used to be in this weird situation when searching for Mb S430 Gps Shark Fin Antenna.
• Before deciding to buy any Mb S430 Gps Shark Fin Antenna, make sure you research and read carefully the buying guide somewhere else from trusted sources. We will not repeat it here to save your time.
• You will know how you should choose Mb S430 Gps Shark Fin Antenna and What you should consider when buying the Mb S430 Gps Shark Fin Antenna and Where to Buy or Purchase the Mb S430 Gps Shark Fin Antenna. Just consider our rankings above as a suggestion. The final choice is yours.
• That’s why we use Big Data and AI to solve the issue. We use our own invented, special algorithms to generate lists of Top 10 brands and give them our own Scores to rank them from 1st to 10th.
• You could see the top 10 Mb S430 Gps Shark Fin Antenna of 2020 above. The lists of best products are updated regularly, so you can be sure that the information provided is up-to-date.
• You may read more about us to know what we have achieved so far. Don’t hesitate to contact us if something’s wrong or mislead information about Mb S430 Gps Shark Fin Antenna.